AMMDENT FLOWABLE

FLOWABLE

COMPOSITION:

Crystalline and fumed silicon dioxide

Bisg-ma

Stabilizer

Photoinitiators

INSTRUCTIONS FOR USE:

TOOTH PREPARATION

Follow usual procedures for tooth preparation. Exposed dentin must be protected by a

Calcium Hydroxide preparation. Glass ionomer or another suitable base can be used to

cover the preparation.

Remove temporary restorations. Isolate and clean the tooth of any traces of temporary

cement.

ETCHING TOOTH SURFACE ENAMEL

Apply etchant over the surface enamel of tooth using a cotton pellet or brush. Allow to

remain for 20-30 seconds. On primary tooth high in fluoride, a 90-120 seconds.

If glass ionomer base is used do not etch for more than 20-30 seconds. Flush area

completely for 20 seconds. Do not allow patient to rinse the mouth or permit saliva to

touch etched enamel surface.

Air dry copletely with an oil/moisture-free air source. The surface of tooth should have a

dull, frosted appearance. If not, repeat the process allowing etchant to remain remain on

tooth for an additinal 20-30 seconds.

Nano optimized

light cure flowable composite