Lubricare 2

Fast, effective, and cost-savings maintenance.

FAST

Thanks to different preprogrammed operating modes suitable for each specific handpiece, Lubricare 2 can automatically perform maintenance of up to four handpieces in a short time Lubricare 2 removes surplus of oil effectively, allowing maintenance in a short time. It cleans a turbine in approximately 20 seconds and a contra-angle in 40 seconds.

EFFECTIVE.

By employing the dual solenoid valves system and a clean air dedicated conduit, the system can supply clean air without a mix of oil. During the water removal process before lubrication, the system removes the water in the head, which maximizes lubrication results and minimizes idling period before practice.

If autoclave sterilization is performed while a large amount of water is left inside the handpiece, steam will not infiltrate, and it could cause a sterilization defect. To prevent this, clean air (without a mix of oil) is fed into the air conduit to remove the residual water, thereby reducing problems occurrence during autoclaving.

HIGH-HYGENE

The control panel is flat for easy cleaning, and the front door can be removed for improved access. Lubricare 2 incorporates a built-in oil mist suction mechanism to prevent aerosol diffusion when in use.

COST-SAVING

When using Lubricare 2, oil consumption is reduced by 25% compared to manual procedure, thus allowing for a faster maintenance with excellent cost savings.

FULL COMPATIBILITY

Lubricare 2 is compatible with all Bien-Air’s turbines and electrical handpieces, Lubrifluid and Spraynet, as well as with handpieces and cleaning or lubrication products from other manufacturers. Additional couplings and spray holder may be needed to use products not supplied by Bien-Air.